Tiêu chuẩn quốc tế

Số hiệu Standard Number AASHTO T 224:2010 Năm ban hành 2010 Publication date Tình trạng W - Hết hiệu lực Status
Tên tiếng Anh Title in English Standard Method of Test for Correction for Coarse Particles in the Soil Compaction Test
Thay thế cho Replace AASHTO T 224:2001
Số trang Page 2 Giá: Price Liên hệ / Contact us
Phạm vi áp dụng Scope of standard This method describes a procedure for adjusting the densities of soil and soil aggregate mixtures to compensate for differing percentages of coarse particles retained on either the 4.75-mm (No. 4) or 19.0-mm (¾-in.) sieve. This is necessary to adjust either the field wet density to a dry density of the material passing these sieves or the reverse, by adjusting the lab density to the field density when doing compaction control testing. Comparisons are made by comparing the field densities with the maximum dry density as determined by T 99 or T 180. Two methods are available for correction: either lab to field or field to lab density. The method specified in Section 4.1 adjusts the compacted lab density to the field density. The method specified in Section 4.2 adjusts the field wet density to dry density of the fine fraction and compares its results with the compacted lab density. This test method applies to soil mixtures that have 40 percent or less retained on the 4.75-mm (No. 4) sieve, when Method A or B of T 99 or T 180 is used, or mixtures that have 30 percent or less retained on the 19.0-mm (¾-in.) sieve, when Method C or D of T 99 or T 180 is used. The material retained on these sieves shall be defined as oversize particles (coarse particles). This method applies to soils with any percentage of oversize particles as specified in Section 1.3. However, the correction may not be of practical significance for soils with only a small percentage of oversize particles. The person or agency specifying this method shall specify a minimum percentage of oversize particles below which the method need not be applied. If a minimum percentage is not specified, this method shall be applied to samples with more than 5 percent by weight of oversize particles. The following applies to all specified limits in this standard: For the purposes of determining conformance with these specifications, an observed value or a calculated value shall be rounded off to the nearest 10 kg/m³ (1 pcf), according to ASTM E 29. The values stated in SI units are to be regarded as the standard.