Tiêu chuẩn quốc tế
|
Số hiệu
Standard Number
ASTM C478-18
Năm ban hành 2018
Publication date
Tình trạng
W - Hết hiệu lực
Status |
|
Tên tiếng Anh
Title in English Standard Specification for Circular Precast Reinforced Concrete Manhole Sections
|
|
Chỉ số phân loại Quốc tế (ICS)
By field |
|
Số trang
Page 9
Giá:
Price Liên hệ / Contact us
|
|
Phạm vi áp dụng
Scope of standard 1.1 This specification covers the manufacture and purchase requirements of products used for the assembly and construction of circular vertical precast reinforced concrete manholes and structures used in sewer, drainage, and water works. 1.2 Part I, Sections 1 - 11, of this specification presents general requirements and requirements that are common to each precast concrete product covered by this specification. 1.3 Part II of this specification presents specific requirements for each manhole product in the following sections: Product Section Grade Rings 12 Flat Slab Tops 13 Risers and Conical Tops 14 Base Sections 15 Steps and Ladders 16 Note 1: Future products will to be included in Part II in a future revision of this specification. 1.4 This specification is the inch-pound companion to Specification C478M; therefore, no SI equivalents are presented in the specification. Note 2: This specification is a manufacturing and purchase specification only and does not include requirements for backfill, or the relationship between field load conditions and the strength requirements of the manhole products and appurtenances. Experience has shown, however, that the successful performance of this product depends upon the proper selection of the product strength, type of foundation and backfill, and care in the field installation of the manhole products and connecting pipes. The owner of the project for which these products are specified herein is cautioned to require inspection at the construction site. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
|