Tiêu chuẩn quốc tế
|
Số hiệu
Standard Number
ASTM D5948-05(2020)
Năm ban hành 2020
Publication date
Tình trạng
A - Còn hiệu lực
Status |
|
Tên tiếng Anh
Title in English Standard Specification for Molding Compounds, Thermosetting
|
|
Chỉ số phân loại Quốc tế (ICS)
By field |
|
Số trang
Page 20
Giá:
Price Liên hệ / Contact us
|
|
Phạm vi áp dụng
Scope of standard 1.1''This specification covers the basic properties of thermoset molding compounds and the test methods used to establish the properties. 1.2''Classification'''Molding thermosetting plastic compounds shall be of the following resins and are covered by the individual specification sheets (see 5.1 and Annex A1 ''' Annex A8). Resin Phenolic, cellulose filled Phenolic, mineral/glass filled Melamine Polyester Diallyl iso-phthalate Diallyl ortho-phthalate Silicone Epoxy Note 1:''There is no known ISO equivalent to this standard. 1.3''Order of Precedence'''In the event of a conflict between the text of this specification and the references cited in Section 2 (except for related specification sheets), the text of this specification takes precedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained. 1.4''The values stated in SI units are to be considered standard. 1.5''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
|