Tiêu chuẩn quốc tế
|
Số hiệu
Standard Number
ASTM D7279-18e1
Năm ban hành 2018
Publication date
Tình trạng
A - Còn hiệu lực
Status |
|
Tên tiếng Anh
Title in English Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids by Automated Houillon Viscometer
|
|
Chỉ số phân loại Quốc tế (ICS)
By field |
|
Số trang
Page 9
Giá:
Price Liên hệ / Contact us
|
|
Phạm vi áp dụng
Scope of standard 1.1 This test method covers the measurement of the kinematic viscosity of transparent and opaque liquids; such as base oils, formulated oils, diesel oil, biodiesel, biodiesel blends, residual fuel oils, marine fuels, and used lubricating oils using a Houillon viscometer in automated mode. 1.2 The range of kinematic viscosity capable of being measured by this test method is from 2 mm²/s to 2500 mm²/s (see Fig. 1). The range is dependent on the tube constant utilized. The temperature range that the apparatus is capable of achieving is between 20 °C and 150 °C, inclusive. However, the precision has only been determined for the viscosity range; 2 mm²/s to 478 mm²/s at 40 °C for base oils, formulated oils, diesel oil, biodiesel, and biodiesel blends; 3 mm²/s to 106 mm²/s at 100 °C for base oils and formulated oils; 25 mm²/s to 150 mm²/s at 40 °C and 5 mm²/s to 16 mm²/s at 100 °C for used lubricating oils; 25 mm²/s to 2500 mm²/s at 50 °C and 6 mm²/s to 110 mm²/s at 100 °C for residual fuels. As indicated for the materials listed in the precision section. FIG. 1 Houillon Viscometer Typical Viscosity Range of Tube Constants Note 1: Viscosity range of a Houillon tube is based on most practical flow time of 30 s to 200 s. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see Section 6. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
|