Tiêu chuẩn quốc tế

• Số hiệu / Standard Number: ASTM F2317/F2317M-05
• Năm ban hành / Publication date: 2005
• Tình trạng / Status: W - Hết hiệu lực
• Tên tiếng Anh / Title in English: Standard Specification for Design of Weight-Shift-Control Aircraft
• Chỉ số phân loại Quốc tế (ICS) / By field: 49.020 - Máy bay và tàu vũ trụ nói chung
• Số trang / Page: 10
• Phạm vi áp dụng / Scope of standard: 1.1 This specification covers the minimum airworthiness standards a manufacturer shall meet in the designing, testing, and labeling of weight-shift-control aircraft.1.2 This specification covers only weight-shift-control aircraft in which flight control systems do not use hinged surfaces controlled by the pilot.Note 1This section is intended to preclude hinged surfaces such as typically found on conventional airplanes such as rudders and elevators. Flexible sail surfaces typically found on weight-shift aircraft are not considered hinged surfaces for the purposes of this specification.1.3 Weight-shift-control aircraft means a powered aircraft with a framed pivoting wing and a fuselage (trike carriage) controllable only in pitch and roll by the pilot's ability to change the aircraft's center of gravity with respect to the wing. Flight control of the aircraft depends on the wing's ability to flexibly deform rather than the use of control surfaces.1.4 This specification is organized and numbered in accordance with the bylaws established for Committee F37. The main sections are:ScopeReferenced DocumentsTerminologyFlight RequirementsStructural RequirementsDesign and Construction RequirementsPowerplant RequirementsEquipment RequirementsOperating LimitationsKeywordsAnnexAppendix1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.